Standard Specification for Low-Carbon Nickel-Chromium-Molybdenum, Low-Carbon Nickel-Chromium-Molybdenum-Copper, Low-Carbon Nickel-Chromium-Molybdenum-Tantalum, Low-Carbon Nickel-Chromium-Molybdenum-Tungsten, and Low-Carbon Nickel-Molybdenum-Chromium Alloy Plate, Sheet, and Strip

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

28-04-2023

Publisher

American Society for Testing and Materials

1.1This specification2 covers plate, sheet, and strip of low-carbon nickel-chromium-molybdenum alloys (UNS N10276, N06022, N06455, N06035, N06044, UNS N06058, UNS N06059),3 low-carbon nickel-chromium-molybdenum-copper alloy (UNS N06200), low-carbon nickel-molybdenum-chromium (UNS N10362), low-carbon nickel-chromium-molybdenum-tantalum alloy (UNS N06210), and low-carbon nickel-chromium-molybdenum-tungsten alloy (UNS N06686) as shown in Table 1, for use in general corrosive service.

1.2The following products are covered under this specification:

1.2.1Sheet and Strip—Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright finish.

1.2.2Plate—Hot or cold rolled, solution annealed, and descaled.

1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	B 02
DocumentType	Standard
Pages	4
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM B 575 : 2017

ASTM G 192 : 2008 : R2020 : EDT 1	Standard Test Method for Determining the Crevice Repassivation Potential of Corrosion-Resistant Alloys Using a Potentiodynamic-Galvanostatic-Potentiostatic Technique
ASTM B 366/B366M : 2023	Standard Specification for Factory-Made Wrought Nickel and Nickel Alloy Fittings
ASTM B 474/B474M : 2019	Standard Specification for Electric Fusion Welded Nickel and Nickel Alloy Pipe
ASTM A 265 : 2012 : R2019	Standard Specification for Nickel and Nickel-Base Alloy-Clad Steel Plate
ASTM B 906 : 2022	Standard Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip

ASTM E 527 : 2023	Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
ASTM E 527 : 2016	Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)