Standard Test Method for Sag Resistance of Paints Using a Multinotch Applicator

Available format(s)

PDF

Language(s)

English

Published date

15-09-2018

Publisher

American Society for Testing and Materials

This test method covers the laboratory determination of the sag resistance of aqueous and nonaqueous liquid coatings at any level of sag resistance

1.1This test method covers the laboratory determination of the sag resistance of aqueous and nonaqueous liquid coatings at any level of sag resistance.

FIG. 1Diagram of the Medium Range Anti-Sag Meter

FIG. 2Medium Range Anti-Sag Meter

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Note 1:Because the only manufacturer of the applicator know to the committee manufactures to inch-pound units, inch-pound units will be regarded as the standard when referring to the applicator.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 01
DocumentType	Redline
Pages	4
ProductNote	THIS STANDARD ALSO REFERS TO ASTM D 2196 Redline version are also available for this standarad.
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 4400 : 1999 : R2012 : EDT 1