Standard Practice for Leaks Using the Mass Spectrometer Leak Detector or Residual Gas Analyzer in the Tracer Probe Mode

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

06-07-2022

Publisher

American Society for Testing and Materials

1.1This practice covers procedures for testing and locating the sources of gas leaking at the rate of 1 × 10⁻⁸ Pa m³/s (1 × 10⁻⁹ Std cm³/s)3 or greater. The test may be conducted on any object to be tested that can be evacuated and to the other side of which helium or other tracer gas may be applied.

1.2Three test methods are described:

1.2.1Test Method A—For the object under test capable of being evacuated, but having no inherent pumping capability.

1.2.2Test Method B—For the object under test with integral pumping capability.

1.2.3Test Method C—For the object under test as in Test Method B, in which the vacuum pumps of the object under test replace those normally used in the leak detector.

1.3Units—The values stated in either SI or std-cc/sec units are to be regarded separately as standard. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	E 07
DocumentType	Standard Practice
Pages	5
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM E 498/E498M : 2011 : R2017

ASTM E 2533 : 2021	Standard Guide for Nondestructive Examination of Polymer Matrix Composites Used in Aerospace Applications
NASA-STD-7012A:2023	LEAK TEST REQUIREMENTS

ASTM E 1316 : 2022 : REV A	Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2024	Standard Terminology for <?Pub Dtl?>Nondestructive Examinations
ASTM E 1316 : 2023 : REV A	Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2023	Standard Terminology for Nondestructive Examinations
ASTM E 1316 : 2023 : REV B	Standard Terminology for Nondestructive Examinations