Standard Practice for Specimens and Testing Conditions for Testing Polyethylene (PE) Pipe Butt Fusions Using Tensile and Hydrostatic Test Methods

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

08-02-2023

Publisher

American Society for Testing and Materials

1.1This practice provides standardized sample butt fusion preparation, conditioning, and testing conditions for tension testing of specimens prepared from sample butt fusion joints or hydrostatic tests of sample butt fusion joints in accordance with:

1.1.1Test Method D638, tension testing;

1.1.1.1The preparation or use of tensile specimens other than Test Method D638 Type I through Type V is beyond the scope of this practice.

1.1.2Test Method D1598, constant (sustained) hydraulic pressure testing;

1.1.3Test Method D1599, short-term hydraulic pressure testing.

1.1.4It is not within the scope of this practice to include plastic materials other than polyethylene or other tests for butt fusions. The exclusion of other plastic materials and other tests does not imply that other plastic materials are suitable or unsuitable for butt fusion, or that the tests cited herein are adequate or inadequate for qualitative characterization and for research and development of butt fusion joints, or that other tests do not have lesser, equal, or greater utility for such purpose.

1.1.5The evaluation of test results and the determination of test result evaluation criteria are not within the scope of this practice. This practice is limited to standardized butt fusion test specimens and testing conditions for the comparison of test data from multiple parties.

1.1.6The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.1.7In this standard, text in parentheses, notes in the body of the standard and appendices are informational and non-mandatory. For tables in the body of the standard, table notes are mandatory.

1.2This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.3This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	F 17
DocumentType	Standard Practice
Pages	6
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM F 2928 : 2018

ASTM F 3123 : 2022	Standard Specification for Metric Outside Diameter Polyethylene (PE) Plastic Pipe (DR-PN)
ASTM F 3525/F3525M : 2021	Standard Specification Fabricated Fittings of Crosslinkable Polyethylene (CX-PE)
ASTM F 645 : 2018 : REV B	Standard Guide for Selection, Design, and Installation of Thermoplastic Water- Pressure Piping Systems

ASTM F 412 : 2021	Standard Terminology Relating to Plastic Piping Systems
ASTM D 1598 : 2023	Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure
ASTM D 1600 : 2018	Standard Terminology for Abbreviated Terms Relating to Plastics (Withdrawn 2024)
ASTM F 412 : 2023	Standard Terminology Relating to Plastic Piping Systems
ASTM D 1598 : 2021	Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure