Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-08-2018

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 08.04, 2018 Defines a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D 2444.

1.1This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444.

1.2This practice is applicable to thermoplastic pipe and fittings.

1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	F 17
DocumentType	Standard Practice
Pages	4
PublisherName	American Society for Testing and Materials
Status	Current
SupersededBy	ASTM F 725 : 2003 ASTM F 725 : 2003 : EDT 1 ASTM F 725 : 2003 : R2008 : EDT 1 ASTM F 725 : 2003 : R2013
Supersedes	ASTM F 725 : 2003 : R2013

ASTM D 2444 : 1999 : R2010	Standard Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
ASTM D 2444 : 2019	Standard Practice for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
ASTM D 2444 : 2017	Standard Practice for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
ASTM D 2444 : 2021	Standard Practice for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
ASTM D 2444 : 1999	Standard Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
ASTM D 2444 : 1999 : R2005	Standard Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)