Standard Specification for Stainless Steel Socket Head Cap Screws [Metric]

Available format(s)

PDF

Language(s)

English

Published date

01-05-2020

Publisher

American Society for Testing and Materials

1.1This specification covers the chemical and mechanical requirements for stainless steel metric socket head cap screws (SHCS) with nominal thread M1.6 through M36 and intended for use in applications requiring general corrosion resistance.

1.2Two groups of stainless steel alloys are covered, austenitic Grade A1 and martensitic Grade C1.

1.3Four property classes are covered: austenitic A1-50 in an annealed condition at 585 MPa maximum; austenitic A1–55 in a cold worked condition at 550 MPa minimum; austenitic A1-70 in a cold worked condition at 700 MPa minimum, and martensitic C1-110 in a heat treated condition at 1100 MPa minimum.

1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5This hazard statement pertains only to Section 13, Test Methods: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	F 16
DocumentType	Redline
Pages	16
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM F 837M : 2016 : REDLINE