BS B 100:1992

Foreword
Committees responsible
Section 1. General
1.1 Scope
1.2 Definitions
1.3 Information and requirements to be agreed and to
      be documented
1.4 Manufacture and freedom from defects
1.5 Heat treatment
1.6 Testing
1.7 Marking
1.8 Protection and packaging
1.9 Certification
Section 2. Rod and sections (including hollow rod and
sections)
2.1 General
2.2 Manufacture
2.3 Inspection and testing
2.4 Marking
Section 3. Forging stock
3.1 General
3.2 Manufacture
3.3 Inspection and testing
3.4 Marking
Section 4. Forgings
4.1 General
4.2 Manufacture
4.3 Pre-production forgings
4.4 Inspection and testing of production forgings
4.5 Marking
Section 5. Seamless tube
5.1 General
5.2 Manufacture
5.3 Inspection and testing
5.4 Marking
Section 6. Sheet, strip and foil
6.1 General
6.2 Manufacture
6.3 Inspection and testing
6.4 Marking
Section 7. Wire
7.1 General
7.2 Manufacture
7.3 Inspection and testing
7.4 Marking
Appendices
A. Rules for application of values for chemical
     composition and mechanical properties given in
     material specifications
B. Method for the detection of residual stress by
     the mercury (1) nitrate test
Tables
1. Nominal batch sizes (masses) for sampling of rods
2. Summary of inspection and testing requirements for
     rod and sections (including hollow rod and sections)
3. Nominal batch sizes (masses) for sampling of forging
     stock
4. Summary of inspection and testing requirements for
     forging stock
5. Nominal batch sizes (masses) for sampling of
     production forgings
6. Summary of inspection and testing requirements for
     production forgings
7. Summary of inspection and testing requirements for
     seamless tube
8. Summary of inspection and testing requirements for
     sheet, strip and foil
9. Summary of inspection and testing requirements for
     wire
Figure
1. Orientation of test pieces for transverse and
     longitudinal bend tests