BS EN ISO 2503:2009+A1:2015

This International Standard specifies requirements for single or two-stage pressure regulators without flow-metering devices for connection to gas cylinders used for compressed gases up to 300bar 1) (30MPa), dissolved acetylene, liquefied petroleum gases (LPG), methylacetylene-propadiene mixtures (MPS), and carbon dioxide (CO 2), for use in welding, cutting and allied processes. It does not cover pressure regulators having a nominal outlet pressure p 2>20 bar. This International Standard also specifies requirements for single or two-stage pressure regulators with flow-metering devices for connection to gas cylinders used for compressed gases or mixtures up to 300bar (30MPa), and carbon dioxide (CO 2), for use in welding, cutting and allied processes. Typical processes using this equipment are: tungsten inert-gas arc welding (TIG), metal-arc inert-gas welding (MIG), metal-arc active-gas welding (MAG), plasma arc welding, tubular-cored-wiretubular-cored-wire welding and plasma cutting. AnnexB gives examples of flow-control systems and their flow-measuring devices. This International Standard does not cover pressure regulators intended for direct use on cylinder bundles. Such regulators comply with the safety requirements of ISO7291 , in particular with the adiabatic compression test for oxygen regulators. NOTE In addition to terms used in English and French, two of the three official ISO languages (English, French and Russian), this document gives the equivalent terms in German; these are published under the responsibility of the member body for Germany (DIN), and are given for information only. Only the terms and definitions given in the official languages can be considered as ISO terms and definitions.