Plastics piping systems. Polyolefin pipes and mechanical fitting assemblies. Test method for the resistance to end load (AREL test)

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

30-11-2010

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
6 Test piece
7 Procedure
8 Test report
Annex A (normative) - End load forces for PE 80 pipes
and PE 100 pipes
Bibliography

Describes a method to determine, for mechanically jointed polyolefin pipe and fitting assemblies in sizes of d[n] less than or equal 63 mm, the effect of component relaxation and creep on the resistance of the assembly to pipe pull out under the long-term application of a constant and longitudinally applied force.

This International Standard specifies a method to determine, for mechanically jointed polyolefin pipe and fitting assemblies in sizes of d_n≤63mm, the effect of component relaxation and creep on the resistance of the assembly to pipe pull out under the long-term application of a constant and longitudinally applied force.

The susceptibility of the polyolefin pipe to stress crack failure initiated by the joint assembly is also examined.

NOTE For sizes d_n>63mm, the method is under development.

Committee	PRI/88/4
DevelopmentNote	Supersedes 05/30127475 DC. (11/2010) Reviewed and confirmed by BSI, February 2016. (02/2016)
DocumentType	Standard
Pages	18
PublisherName	British Standards Institution
Status	Current
Supersedes	05/30127475 DC : DRAFT JAN 2005

Standards	Relationship
ISO 19899:2010	Identical

ISO 1167-4:2007	Thermoplastics pipes, fittings and assemblies for the conveyance of fluids Determination of the resistance to internal pressure Part 4: Preparation of assemblies
ISO 3:1973	Preferred numbers Series of preferred numbers
ISO 497:1973	Guide to the choice of series of preferred numbers and of series containing more rounded values of preferred numbers
ISO 3458:2015	Plastics piping systems Mechanical joints between fittings and pressure pipes Test method for leaktightness under internal pressure
ISO 1167-1:2006	Thermoplastics pipes, fittings and assemblies for the conveyance of fluids Determination of the resistance to internal pressure Part 1: General method

View more information

$294.12

Including GST where applicable

Product format

I agree to the DRM document license rules apply against the PDF selection made.

Please confirm that you agree to the document license rules for this document.

I agree to the document license rules .

Please confirm that you agree to the document license rules for this document.

Access your standards online with a subscription

Features

Simple online access to standards, technical information and regulations.
Critical updates of standards and customisable alerts and notifications.
Multi-user online standards collection: secure, flexible and cost effective.

Learn more on subscription solutions

Get in touch with us

BS ISO 19899:2010

Plastics piping systems. Polyolefin pipes and mechanical fitting assemblies. Test method for the resistance to end load (AREL test)

Table of Contents

Abstract

Scope

General Product Information

International Equivalents

Standards Referencing This Book

Category

Subcategory