EN 300 793 : 1.1.1

Intellectual Property Rights
Foreword
Introduction
1 Scope
2 References
3 Definitions and symbols
  3.1 Definitions
  3.2 Symbols
4 Presentation of equipment for testing purposes
  4.1 Choice of model for type testing
  4.2 Definitions of switching range, alignment
       range and operational frequency range
  4.3 Definition of the categories of the alignment
       range (AR0, AR1, AR2 and AR3)
  4.4 Testing of equipment of category AR0
  4.5 Testing of equipment of category AR1
  4.6 Testing of equipment of category AR2
  4.7 Testing of equipment of category AR3
  4.8 Testing of equipment capable of operating with
       more than one channel separations
  4.9 Number of samples for type testing
  4.10 Testing of a family of equipment with a total
       operating range in excess of each equipment's
       alignment range
  4.11 Testing of equipment with alternative transmitter
       power levels
  4.12 Testing of equipment with alternative hardware
       configurations
  4.13 Testing of equipment that does not have an
       external 50 Ohms RF connector (integral
       antenna equipment)
Annex A (normative): Graphical representation of the
        selection of equipment and frequencies for testing
      A.1 Tests on a single sample
      A.2 Tests and samples needed when the switching
          range is a subset of the alignment range
      A.3 Tests and samples for a family of equipment
          where the alignment range is a subset of the
          total operating frequency range
Annex B (informative): Examples of limited tests in
        ETSI standards
      B.1 Limited tests
      B.2 Example of limited tests from ETS 300 086
      B.3 Example of limited tests from ETS 300 341
History