FAA AC 150/5345-10 : 2005

CHAPTER 1 SCOPE AND CLASSIFICATION
        1.1 SCOPE
        1.2 CLASSIFICATION
            1.2.1 Types
            1.2.2 Classes
            1.2.3 Styles
            1.2.4 Standard Ratings
CHAPTER 2 REFERENCED DOCUMENTS
        2.1 GENERAL
        2.2 FAA ADVISORY CIRCULARS
        2.3 FAA STANDARDS
        2.4 CODE OF FEDERAL REGULATIONS
        2.5 INSTITUTE OF ELECTRICAL AND ELECTRONICS ENGINEERS,
            AMERICAN NATIONAL STANDARDS INSTITUTE (IEEE/ANSI)
            PUBLICATIONS
        2.6 MILITARY STANDARDS
        2.7 NATIONAL ELECTRIC MANUFACTURERS ASSOCIATION (NEMA)
        2.8 INTERNATIONAL ELECTROTECHNICAL COMMISSION (IEC)
CHAPTER 3 EQUIPMENT REQUIREMENTS
        3.1 GENERAL
        3.2 ENVIRONMENTAL REQUIREMENTS
        3.3 PERFORMANCE REQUIREMENTS
            3.3.1 Regulation
            3.3.2 Efficiency
            3.3.3 Power Factor
            3.3.4 Standard Input Voltage
            3.3.5 Temperature Rise
            3.3.6 Crest Factor
            3.3.7 CCR Control System
            3.3.8 Output Current Surge Limitation
            3.3.9 CCR Circuit Isolation
            3.3.10 Protective Devices
            3.3.11 Input Power Loss
            3.3.12 Electromagnetic Interference
        3.4 DETAILED REQUIREMENTS
            3.4.1 Primary Switch
            3.4.2 Operator Controls
            3.4.3 Output Ammeter
            3.4.4 Output Voltmeter
            3.4.5 Operator Display
            3.4.6 Terminal Block
            3.4.7 CCR Enclosure
            3.4.8 Control Cabinet
            3.4.9 Capacitors
            3.4.10 Wiring Diagram
            3.4.11 Painting and Finishing
            3.4.12 Lightning/Surge Arresters
            3.4.13 Transient Voltage and Current Protection
            3.4.14 Warning
            3.4.15 Components
            3.4.16 Nameplate
            3.4.17 Instruction Book
        3.5 MONITOR
CHAPTER 4 EQUIPMENT CERTIFICATION REQUIREMENTS
        4.1 CERTIFICATION PROCEDURES
        4.2 CERTIFICATION TESTING
            4.2.1 Regulation Test
            4.2.2 Remote Control Test
            4.2.3 Temperature Rise
            4.2.4 Efficiency
            4.2.5 Power Factor
            4.2.6 Crest Factor
            4.2.7 Altitude
            4.2.8 Low Temperature
            4.2.9 Humidity
            4.2.10 Electromagnetic Interference Tests
            4.2.11 Basic Impulse Insulation Level (BIL) Tests
            4.2.12 Dielectric Tests
            4.2.13 Protective Device Tests
            4.2.14 Leakage Test
            4.2.15 Output Current Surge
            4.2.16 Monitor Test
        4.3 OUTPUT WAVEFORMS
CHAPTER 5 PRODUCTION TEST REQUIREMENTS
        5.1 PRODUCTION TESTING