Preview

ADVANCED TECHNICAL CERAMICS - METHODS OF TEST FOR CERAMIC COATINGS - PART 12: RECIPROCATING WEAR TEST

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-01-2010

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Significance and use
5 Principle
6 Apparatus and materials
7 Preparation of test pieces
8 Test procedure
9 Repeatability and limits
10 Test report
Annex A (informative) - Issues related to dynamic
        measurements in reciprocating wear testing
Annex B (informative) - Methods for the determination
        of coating properties likely to be relevant to
        coating performance in a reciprocating wear test
Annex C (informative) - Examples of common wear mechanisms
Annex D (informative) - Determination of volume loss from
        the pin using profilometry
Annex E (informative) - Determination of wear of coated
        plate by ball crater technique
Bibliography

Defines a method for evaluating the wear of ceramic coatings by use of a reciprocating wear test whereby a flat or spherically ended pin is reciprocated, under load, against a flat plate.

DocumentType	Standard
Pages	32
PublisherName	National Standards Authority of Ireland
Status	Current

Standards	Relationship
EN 1071-12:2010	Identical

ISO/IEC 17025:2005	General requirements for the competence of testing and calibration laboratories
EN 1071-6:2007	Advanced technical ceramics - Methods of test for ceramic coatings - Part 6: Determination of the abrasion resistance of coatings by a micro-abrasion wear test
DIN 51834-2:2016-03 (Draft)	TESTING OF LUBRICANTS - TRIBOLOGICAL TEST IN THE TRANSLATORY OSCILLATION APPARATUS - PART 2: DETERMINATION OF FRICTION AND WEAR DATA FOR LUBRICATING OILS
ISO 14577-4:2016	Metallic materials Instrumented indentation test for hardness and materials parameters Part 4: Test method for metallic and non-metallic coatings
ISO 1101:2017	Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out
CEN/TS 1071-11 : 2005	ADVANCED TECHNICAL CERAMICS - METHODS OF TEST FOR CERAMIC COATINGS - PART 11: DETERMINATION OF INTERNAL STRESS BY THE STONEY FORMULA
EN 1071-13:2010	Advanced technical ceramics - Methods of test for ceramic coatings - Part 13: Determination of wear rate by the pin-on-disk method
EN ISO 14577-4:2016	Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 4: Test method for metallic and non-metallic coatings (ISO 14577-4:2016)

View more information

$105.88

Including GST where applicable

Product format

I agree to the DRM document license rules apply against the PDF selection made.

Please confirm that you agree to the document license rules for this document.

I agree to the document license rules .

Please confirm that you agree to the document license rules for this document.

Access your standards online with a subscription

Features

Simple online access to standards, technical information and regulations.
Critical updates of standards and customisable alerts and notifications.
Multi-user online standards collection: secure, flexible and cost effective.

Learn more on subscription solutions

Get in touch with us

I.S. EN 1071-12:2010

ADVANCED TECHNICAL CERAMICS - METHODS OF TEST FOR CERAMIC COATINGS - PART 12: RECIPROCATING WEAR TEST

Table of Contents

Abstract

General Product Information

International Equivalents

Standards Referencing This Book

Category

Subcategory