I.S. EN 61290-10-1:2009
Current
The latest, up-to-date edition.
OPTICAL AMPLIFIERS - TEST METHODS - PART 10-1: MULTICHANNEL PARAMETERS - PULSE METHOD USING AN OPTICAL SWITCH AND OPTICAL SPECTRUM ANALYZER
Hardcopy , PDF
English
01-01-2009
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
INTRODUCTION
1 Scope and object
2 Normative references
3 Abbreviated terms
4 Apparatus
5 Test sample
6 Procedure
6.1 Calibration
6.1.1 Calibration of OSA power measurement
6.1.2 Calibration of the pulse duty ratio
6.1.3 Calibration of the sampling module
6.1.4 Calibration of dynamic isolation
6.2 OA measurement
6.2.1 Timing adjustment for ASE and amplified signal
power measurement
6.2.2 ASE measurement
6.2.3 Amplified signal power measurement
7 Calculation
7.1 General
7.2 Noise factor calculation
7.3 ASE power
7.4 Gain calculation
7.5 Average output signal power
7.6 Noise figure calculation
8 Test results
Annex A (informative) - Output waveforms for various EDFAs
at 25 kHz and 500 kHz pulse rates
Annex B (informative) - Measurement accuracy versus pulse rate
Annex C (informative) - Pulse repetition frequency measurements
Bibliography
Annex ZA (normative) - Normative references to international
publications with their corresponding European
publications
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.