I.S. EN 710:1998+A1:2010
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Safety of machinery - Safety requirements for foundry moulding and coremaking machinery and plant and associated equipment
Hardcopy , PDF
23-11-2021
English
27-05-2010
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative References
3 Terms and definitions
4 Significant hazards
5 Safety requirements and/or protective measures
6 Verification of the safety requirements and/or preventative measures
7 Information for use
Annex A (normative) !Preventing hazards from hydraulic and pneumatic equipment"
Annex B (informative) Main components of hazardous gases and fumes during the application of
moulding material binders and coatings for cores and moulds
Annex ZA (informative) !Relationship between this European Standard and the Essential
Requirements of EU Directive 98/37/EC"
Annex ZB (informative) !Relationship between this European Standard and the Essential
Requirements of EU Directive 2006/42/EC"
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.