Preview

WELDING - TEST FOR SHOP PRIMERS IN RELATION TO WELDING AND ALLIED PROCESSES - PART 3: THERMAL CUTTING

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

12-09-2003

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Procedure
  4.1 Preparation of test pieces
  4.2 Acceptance criteria for cuts
  4.3 Cutting data
  4.4 Initial cutting of test plate without shop primer
  4.5 Cutting of test plate(s) with shop primer
  4.6 Final cutting of test plate without shop primer
5 Assessment of results
6 Test reports
Annex ZA (informative) Corresponding International and European
         Standards for which equivalents are not given in the text

Provides a test method for determination of a shop primers influence on the maximum speed usable for thermal cutting.

Committee	TC 44
DocumentType	Test Method
Pages	30
ProductNote	The date of any NSAI previous adoption may not match the date of its original CEN/CENELEC document. THIS STANDARD ALSO REFERS TO EN 10025,EN ISO 8501-1:1988
PublisherName	National Standards Authority of Ireland
Status	Current

Standards	Relationship
EN ISO 17652-3:2003	Identical
NBN EN ISO 17652-3 : 2003	Identical
NF EN ISO 17652-3 : 2003	Identical
UNI EN ISO 17652-3 : 2004	Identical
BS EN ISO 17652-3:2003	Identical
NS EN ISO 17652-3 : 1ED 2003	Identical
SN EN ISO 17652-3 : 2003	Identical
NEN EN ISO 17652-3 : 2003	Identical
UNE-EN ISO 17652-3:2004	Identical
ISO 17652-3:2003	Identical
DIN EN ISO 17652-3:2003-07	Identical
DIN EN ISO 17652-3 E : 2003	Identical