I.S. EN ISO 20430:2020
Current
The latest, up-to-date edition.
Plastics and rubber machines - Injection moulding machines - Safety requirements (ISO 20430:2020)
Hardcopy , PDF
English
20-07-2020
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
4 Safety requirements and/or protective/risk reduction measures
5 Verification of the safety requirements and/or protective measures
6 Information for use
Annex A (informative) List of significant hazards
Annex B (normative) Protective Type I
Annex C (normative) Protective Type II
Annex D (normative) Protective Type III
Annex E (normative) Two-hand control device for the mould area
Annex F (normative) Acknowledgement system
Annex G (normative) Use of proportional valves for the platen movement
Annex H (informative) Warning signs, prohibition signs and mandatory action signs
Annex I (normative) Noise test code
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.