NEN EN 13022-1 : 2014

Foreword
1 Scope
2 Normative references
3 Symbols, terminology, terms and definitions
  3.1 Symbols
  3.2 Terminology
  3.3 Terms and definitions
4 Characteristics of glass products - requirements
  4.1 Appropriate glass products
  4.2 Dimensional tolerances
  4.3 Glass shapes
      4.3.1 Curved glass
  4.4 Corners, notches and holes
5 Verification of the suitability of glass products for
  use in SSG systems when exposed to UV radiation
  5.1 General
  5.2 Insulating glass unit (IGU)
      5.2.1 Situation 1
      5.2.2 Situation 2
      5.2.3 Coated glass
      5.2.4 Possibility to substitute the outer IGU seal
      5.2.5 Further requirements for the outer IGU seal
            when in an unsupported case
  5.3 Monolithic glass or laminated glass, Situation 3
  5.4 Assessment of the adhesion between the sealant and
      the glass
      5.4.1 Clear float
      5.4.2 Coated glass
      5.4.3 Enamelled glass
      5.4.4 Patterned glass
6 Design
  6.1 Calculation of the thickness of the glass
  6.2 Calculation of the height of the outer sealant of the
      insulating glass unit for supported and unsupported
      glazing
      6.2.1 Supported insulating glass unit
  6.3 Calculation of the height of the outer sealant of the
      insulating glass unit for unsupported glazing
      6.3.1 Calculation of the height regarding the relevant
            combined load of the wind, snow and self weight
            and relevant combined load for wind, snow and self
            weight
      6.3.2 Calculation of the height of the outer seal to
            bear the permanent shear loading
7 Minimum glass thickness
  7.1 General case
  7.2 Case of glass with worked edges
Annex A (informative) Assembly requirement
  A.1 Setting blocks for glass panes or Insulating Glass Units
      A.1.1 General case
      A.1.2 Supporting the self-weight of a monolithic glass
  A.2 Water drainage from the system
Bibliography