SN EN 61347-2-1 : 2001 AMD 1 2006

INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
5 General notes on tests
    5.1 Starting devices for use with lamps having different
         electrical characteristics
    5.2 Number of specimens
6 Classification
7 Marking
    7.1 Mandatory markings
    7.2 Information to be provided, if applicable
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Fault conditions
15 Heating of independent starting devices
    15.1 Normal operation
    15.2 Abnormal operation
16 Pulse voltage of ignitors
17 Mechanical strength
18 Construction
19 Creepage distances and clearances
20 Screws, current-carrying parts and connections
21 Resistance to heat, fire and tracking
22 Resistance to corrosion
Annex A (normative) Test to establish whether a conductive
        part is a live part which may cause an electric shock
Annex B (normative) Particular requirements for thermally
        protected lamp controlgear
Annex C (normative) Particular requirements for electronic
        lamp controlgear with means of protection against
        overheating
Annex D (normative) Requirements for carrying out the
        heating tests of thermally protected lamp
        controlgear
Annex E (normative) Use of constant S other than 4500 in t[w]
        tests
Annex F (normative) Draught-proof enclosure
Annex G (informative) Explanation of the derivation of the
        values of pulse voltages
Annex H (normative)
Annex I (normative) Mechanical strength testing
Annex J (normative) Precautions to be observed when measuring
        with sphere-gaps
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications
Bibliography