ASTM B 85/B85M : 2014

Name: ASTM B 85/B85M : 2014
Brand: ASTM
Price: 64.04 GBP

Superseded

View Superseded by

Standard Specification for Aluminum-Alloy Die Castings

Available format(s)

Hardcopy , PDF

Superseded date

11-11-2014

Language(s)

English

Published date

01-10-2014

Publisher

American Society for Testing and Materials

1.1This specification covers aluminum-alloy die castings of all compositions. Thirteen of the most commonly die cast alloy compositions are specified, designated as shown in Table 1.

(A)Analysis shall ordinarily be made only for the elements mentioned in this table. If, however, the presence of other elements is suspected, or indicated in the course of routine analysis, further analysis shall be made to determine that the total of these other elements are not present in excess of specified limits.

(B)For purposes of acceptance and rejection, the observed value or calculated value obtained from analysis should be rounded off to the nearest unit in the last right-hand place of figures, used in expressing the specified limit, in accordance with the rounding procedure prescribed in Section 3 of Practice E29.

(C)Limits are in percent maximum unless shown otherwise.

(D)Alloys 360.0, 380.0, 413.0, C443.0 and 518.0 are suitable for the production of die casting by either the hot-chamber or the cold-chamber process. Die castings of alloys A360.0, A380.0, 383.0, 384.0 and A413.0 may be made only in cold-chamber machines. ASTM designations were established in accordance with Practice B275. ANSI designations were established in accordance with ANSI H35.1/H35.1 (M). UNS designations were established in accordance with Practice E527.

(E)”Others” includes listed elements for which no specific limit is shown as well as unlisted metallic elements. The producer may analyze samples for trace elements not specified in the registration or specification. However, such analysis is not required and may not cover all metallic “other” elements. Should any analysis by the producer or the purchaser establish that the aggregate of several “others” elements exceeds the limit of the “Total” the material shall be considered non-conforming.

(F)The sum of those “others” metallic elements 0.010 percent or more, each expressed to the second decimal before determining the sum.

(G)With respect to mechanical properties, alloys A380.0, 383.0 and 384.0 are substantially interchangeable.

1.2This specification is not intended for aluminum-alloy die castings used in aerospace applications.

1.3Alloy and temper designations are in accordance with ANSI H35.1/H35.1(M). The equivalent unified numbering system alloy designations are in accordance with Practice E527.

1.4Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units.

1.5For acceptance criteria for inclusion of new aluminum and aluminum alloys and their properties in this specification, see Annex A1 and Annex A2.

1.6Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.7This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Committee	B 07
DocumentType	Standard
Pages	10
PublisherName	American Society for Testing and Materials
Status	Superseded
SupersededBy	ASTM B 85/B85M : 2018 : EDT 1 ASTM B 85/B85M : 2018
Supersedes	ASTM B 85/B85M : 2013