We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • ASTM C 367/C367M : 2016 : REDLINE

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    Standard Test Methods for Strength Properties of Prefabricated Architectural Acoustical Tile or Lay-In Ceiling Panels

    Available format(s):  PDF

    Superseded date:  20-06-2022

    Language(s):  English

    Published date:  01-05-2016

    Publisher:  American Society for Testing and Materials

    Add to Watchlist

    Add To Cart

    Abstract - (Show below) - (Hide below)

    CONTAINED IN VOL. 04.06, 2016 Defines the determination of the strength properties of prefabricated architectural acoustical tile or lay-in ceiling panels.

    Scope - (Show below) - (Hide below)

    1.1These test methods cover the determination of the strength properties of prefabricated architectural acoustical tile or lay-in ceiling panels as follows:




    4 to 9


    10 to 16


    17 to 23

    Transverse strength

    24 to 30

    1.2Not all of the tests described in these test methods are necessary to evaluate any particular product for a specific use. In each instance, it is necessary to determine which properties are required.

    1.3These test methods specify procedures that are used in product development, manufacturing control, specification acceptance, and service evaluation.

    1.4Properties determined by these test methods reflect the performance of the materials under the specific conditions of the test, and do not necessarily indicate performance under conditions other than those specified herein.

    1.5The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems will result in non-conformance with the standard.

    1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    General Product Information - (Show below) - (Hide below)

    Committee E 33
    Development Note Supersedes ASTM C 367. (02/2010)
    Document Type Redline
    Publisher American Society for Testing and Materials
    Status Superseded
    Superseded By
    • Access your standards online with a subscription


      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective