ASTM D 2060 : 2000 : R2005 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Test Methods for Measuring Zipper Dimensions
Hardcopy , PDF
11-11-2014
English
01-03-2005
1.1 These test methods cover the measurement of the dimensions of all types and sizes of zippers.
1.2 The test methods appear as follows:
| Sections | |
| Chain Flatness | 34-39 |
| Chain Straightness | 40-44 |
| Chain Thickness | 28-33 |
| Length of Zipper or Parts | 9-14 |
| Longitudinal Dimensional Change | 45-52 |
| Slider Mouth Width | 21-27 |
| Tape Width | 15-20 |
1.3 The values stated in either SI units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.