• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

ASTM D 3381/D3381M : 2012

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction

Available format(s)

Hardcopy , PDF

Superseded date

11-11-2014

Language(s)

English

Published date

01-12-2012

1.1This specification covers asphalt cements graded by viscosity at 60°C [140°F] for use in pavement construction. Three sets of limits are offered in this specification. The purchaser shall specify the applicable table of limits. In the event the purchaser does not specify limits, Table 1 shall apply. For asphalt cements graded by penetration at 25°C [77°F]. See Specification D946. If needed, volume corrections for asphalt cements should be made according to Practice D4311.

TABLE 1 Requirements for Asphalt Cement, Viscosity Graded at 60°C [140°F]
Note 1Grading based on original asphalt.

Test

Viscosity Grade

AC-2.5

AC-5

AC-10

AC-20

AC-30

AC-40

Viscosity, 60°C [140°F], Pa·s

25 ± 5

50 ± 10

100 ± 20

200 ± 40

300 ± 60

400 ± 80

Viscosity, 135°C [275°F], min, mm2/s

80

110

150

210

250

300

Penetration, 25°C [77°F], 100 g, 5 s, min

200

120

70

40

30

20

Flash point, Cleveland open cup, min,°C [°F]

165 [325]

175 [350]

220 [425]

230 [450]

230 [450]

230 [450]

Solubility in trichloroethylene, min, %

99.0

99.0

99.0

99.0

99.0

99.0

Tests on residue from thin-film oven test:

 Viscosity, 60°C [140°F], max, Pa·s

125

250

500

1000

1500

2000

 Ductility, 25°C [77°F], 5 cm/min, min, cm

100A

100

50

20

15

10

A If ductility is less than 100, material will be accepted if ductility at 15°C [60°F] is 100 minimum at a pull rate of 5 cm/min.

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Committee
D 04
DocumentType
Standard
Pages
3
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

View more information
£56.36
Excluding VAT

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.