Standard Practice for Inspection of Linings in Operating Flue Gas Desulfurization Systems

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-08-2018

Publisher

American Society for Testing and Materials

1.1This practice describes procedures for conducting inspections of the conditions of various linings in operating Flue Gas Desulfurization (FGD) system components.

1.2This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8.

1.3This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 33
DocumentType	Standard Practice
Pages	3
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 4619 : 2012

ASTM D 2240 : 2000	Standard Test Method for Rubber Property—Durometer Hardness
ASTM D 7091 : 2022	Standard Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals
ASTM D 4541 : 2017	Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers
ASTM D 4541 : 2022	Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers
ASTM D 6677 : 2001	Standard Test Method for Evaluating Adhesion by Knife
ASTM D 7091 : 2021	Standard Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals
ASTM D 6677 : 2018	Standard Test Method for Evaluating Adhesion by Knife
ASTM D 7091 : 2005	Standard Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals
ASTM D 6677 : 2018 : R2022	Standard Test Method for Evaluating Adhesion by Knife
ASTM D 4541 : 1995 : EDT 1	Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers