• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

ASTM D 6622/D6622M : 2001 : R2018 : EDT 1

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Guide for Application of Fully Adhered Hot-Applied Reinforced Waterproofing Systems
Available format(s)

Hardcopy , PDF

Superseded date

03-09-2020

Language(s)

English

Published date

01-01-2018

CONTAINED IN VOL. 04.04, 2018 Defines the minimum installation recommendations for fully adhered, hot-applied reinforced waterproofing systems on vertical and low-slope (plaza deck) surfaces.

1.1This guide covers the minimum installation recommendations for fully adhered, hot-applied reinforced waterproofing systems on vertical and low-slope (plaza deck) surfaces.

1.2For the purpose of this guide, the substrate is assumed to be concrete or masonry, structurally sound, able to accept the weight of anticipated loads, and meets the local building code requirements. Similarly, all components of the waterproofing system are assumed to comply with any federal, state, and local environmental regulations that may be in effect at the time of installation. Expansion joints, insulation, drainage layers, and overburden are beyond the scope of this guide.

1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee
D 08
DevelopmentNote
Supersedes ASTM D 6622. (01/2018)
DocumentType
Guide
Pages
4
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

ASTM D 1079 : 2018 : EDT 1 Standard Terminology Relating to Roofing and Waterproofing
ASTM D 227/D227M : 2003 : R2011 : EDT 1 Standard Specification for Coal-Tar-Saturated Organic Felt Used in Roofing and Waterproofing
ASTM D 1079 : 2008 : REV A Standard Terminology Relating to Roofing and Waterproofing
ASTM D 4990 : 1997 : REV A : R2005 : EDT 1 Standard Specification for Coal Tar Glass Felt Used in Roofing and Waterproofing
ASTM D 5295 : 2000 Standard Guide for Preparation of Concrete Surfaces for Adhered (Bonded) Membrane Waterproofing Systems
ASTM D 449/D449M : 2003 : R2014 : EDT 1 Standard Specification for Asphalt Used in Dampproofing and Waterproofing
ASTM D 1079 : 2016 Standard Terminology Relating to Roofing and Waterproofing
ASTM D 1079 : 2006 Terminology Relating to Roofing and Waterproofing
ASTM D 1079 : 2020 Standard Terminology Relating to Roofing and Waterproofing
ASTM D 4990 : 1997 : REV A : R2013 Standard Specification for Coal Tar Glass Felt Used in Roofing and Waterproofing
CGSB 37.51 : M90 APPLICATION FOR HOT-APPLIED RUBBERIZED ASPHALT, FOR ROOFING AND WATERPROOFING
ASTM D 5957 : 1998 : R2005 Standard Guide for Flood Testing Horizontal Waterproofing Installations
ASTM D 5295 : 2000 : R2006 Standard Guide for Preparation of Concrete Surfaces for Adhered (Bonded) Membrane Waterproofing Systems
ASTM D 6162/D6162M : 2016 : REDLINE Standard Specification for Styrene Butadiene Styrene (SBS) Modified Bituminous Sheet Materials Using a Combination of Polyester and Glass Fiber Reinforcements
ASTM D 1079 : 2013 Standard Terminology Relating to Roofing and Waterproofing
ASTM D 1079 : 2007 : REV A Terminology Relating to Roofing and Waterproofing
ASTM D 1079 : 2010 Standard Terminology Relating to Roofing and Waterproofing
CGSB 37.50 : M89 HOT APPLIED, RUBBERIZED ASPHALT FOR ROOFING AND WATERPROOFING
ASTM D 6163/D6163M : 2016 : REDLINE Standard Specification for Styrene Butadiene Styrene (SBS) Modified Bituminous Sheet Materials Using Glass Fiber Reinforcements
ASTM D 5726 : 1998 Standard Specification for Thermoplastic Fabrics Used in Hot-Applied Roofing and Waterproofing
ASTM D 1079 : 2018 Standard Terminology Relating to Roofing and Waterproofing
ASTM D 5726 : 1998 : R2005 Standard Specification for Thermoplastic Fabrics Used in Hot-Applied Roofing and Waterproofing
ASTM D 1668/D1668M : 1997 : REV A : R2014 : EDT 1 Standard Specification for Glass Fabrics (Woven and Treated) for Roofing and Waterproofing
ASTM D 6451/D6451M : 1999 : R2014 : EDT 1 Standard Guide for Application of Asphalt Based Protection Board
ASTM D 450/D450M : 2007 : R2013 : EDT 1 Standard Specification for Coal-Tar Pitch Used in Roofing, Dampproofing, and Waterproofing
ASTM D 1079 : 2005 : REV A Terminology Relating to Roofing and Waterproofing
ASTM D 5957 : 1998 : R2013 Standard Guide for Flood Testing Horizontal Waterproofing Installations
ASTM D 226/D226M : 2017 : REDLINE Standard Specification for Asphalt-Saturated Organic Felt Used in Roofing and Waterproofing
ASTM D 1079 : 2002 Standard Terminology Relating to Roofing, Waterproofing, and Bituminous Materials
ASTM D 5726 : 1998 : R2013 Standard Specification for Thermoplastic Fabrics Used in Hot-Applied Roofing and Waterproofing
ASTM D 6164/D6164M : 2016 : REDLINE Standard Specification for Styrene Butadiene Styrene (SBS) Modified Bituminous Sheet Materials Using Polyester Reinforcements
ASTM D 1079 : 2001 Standard Terminology Relating to Roofing, Waterproofing, and Bituminous Materials
ASTM D 4990 : 1997 : REV A Standard Specification for Coal Tar Glass Felt Used in Roofing and Waterproofing
ASTM D 5957 : 1998 Standard Guide for Flood Testing Horizontal Waterproofing Installations
ASTM D 4990 : 1997 : REV A : R2020 Standard Specification for Coal-Tar Glass Felt Used in Roofing and Waterproofing
ASTM D 1079 : 2000 : REV A Standard Terminology Relating to Roofing, Waterproofing, and Bituminous Materials
ASTM D 173/D173M : 2003 : R2011 : EDT 1 Standard Specification for Bitumen-Saturated Cotton Fabrics Used in Roofing and Waterproofing
ASTM D 1079 : 2013 : EDT 1 Standard Terminology Relating to Roofing and Waterproofing
ASTM D 1079 : 2009 Standard Terminology Relating to Roofing and Waterproofing

View more information
£55.10
Excluding VAT

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.