Standard Test Method for Wet Filterability of Lubricants and Hydraulic Fluids by Mass Flow Technique

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-03-2020

Publisher

American Society for Testing and Materials

1.1This test method covers determination of the wet filterability of lubricants and hydraulic fluids based upon mass flow rate measurements through a 0.8 µm membrane after ageing of the fluid in the presence of water. The procedure applies to lubricants and hydraulic fluids that are formulated with American Petroleum Institute (API) Group I, II, III, IV and certain V base stocks. Products formulated with water or base stocks that are heavier than water are out of scope.

1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 02
DocumentType	Test Method
Pages	4
PublisherName	American Society for Testing and Materials
Status	Current

ASTM D 6300 : 2023 : REV A	Standard Practice for Determination of Precision and Bias Data for Use in Test Methods for Petroleum Products, Liquid Fuels, and Lubricants
ASTM D 6300 : 2024	Standard Practice for Determination of Precision and Bias Data for Use in Test Methods for Petroleum Products, Liquid Fuels, and Lubricants