Standard Test Method for Measuring Rut-Depth of Pavement Surfaces Using a Straightedge

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

06-03-2023

Publisher

American Society for Testing and Materials

1.1This test method describes the procedure for the measurement of the depth of the rut at a chosen location in a pavement surface using a straightedge and a gauge.

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	E 17
DocumentType	Test Method
Pages	2
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM E 1703/E1703M : 2010 : R2015

ASTM E 2133 : 2003 : R2020	Standard Test Method for Using a Rolling Inclinometer to Measure Longitudinal and Transverse Profiles of a Traveled Surface
ASTM E 867 : 2006 : R2020	Standard Terminology Relating to Vehicle-Pavement Systems

ASTM E 867 : 2023	Standard Terminology Relating to Vehicle-Pavement Systems
ASTM E 867 : 2006 : R2020	Standard Terminology Relating to Vehicle-Pavement Systems