Standard Test Method for Determining the Superplastic Properties of Metallic Sheet Materials

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

25-01-2023

Publisher

American Society for Testing and Materials

1.1This test method describes the procedure for determining the superplastic forming properties (SPF) of a metallic sheet material. It includes tests both for the basic SPF properties and also for derived SPF properties. The test for basic properties encompasses effects due to strain hardening or softening.

1.2This test method covers sheet materials with thicknesses of at least 0.5 mm but not greater than 6 mm. It characterizes the material under a uni-axial tensile stress condition.

Note 1:Most industrial applications of superplastic forming involve a multi-axial stress condition in a sheet; however it is more convenient to characterize a material under a uni-axial tensile stress condition. Tests should be performed in different orientations to the rolling direction of the sheet to ascertain initial anisotropy.

1.3This method has been used successfully between strain rates of 10^-5 mm/mm/s to 10^-1 mm/mm/s second.

1.4This method has been used successfully on Aluminum and Titanium alloys. The use of the method with other metals should be verified.

1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	E 28
DocumentType	Test Method
Pages	8
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM E 2448 : 2018

ASTM E 2712 : 2022	Standard Test Methods for Bulge-Forming Superplastic Metallic Sheet
ASTM E 633 : 2021 : REV A	Standard Guide for Use of Thermocouples in Elevated-Temperature Mechanical Testing

ASTM E 691 : 2023	Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM E 691 : 2022	Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM E 6 : 2023 : REV A	Standard Terminology Relating to Methods of Mechanical Testing
ASTM E 6 : 2015 : EDT 4 : REDLINE	Standard Terminology Relating to Methods of Mechanical Testing
ASTM E 6 : 2015 : EDT 4	Standard Terminology Relating to Methods of Mechanical Testing
ASTM E 6 : 2023	Standard Terminology Relating to Methods of Mechanical Testing