BS 1916-1:1953
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Limits and fits for engineering Limits and tolerances
Hardcopy , PDF
30-09-2009
English
18-03-1953
Cooperating organizations
Foreword
General notes on the system
Specification
1. Scope
2. Definitions relating to limits and fits
3. Basis of conversion
4. Diameter steps
5. Explanation of the system
6. Terminology
7. Selection of limits
8. Initial selection for normal use
9. Gauge limits
10. Equivalent fits
Tables
1. Fundamental tolerances, grades 1 to 16. Inch units
2. Limits for holes. Inch units
3. Limits for shafts. Inch units
Figures
1. Diagram showing the disposition of limits and
tolerances
2. Tolerance zones for holes arranged according
to symbol
3. Tolerance zones for shafts arranged according
to symbol
4. Recommended selection of fits for general
engineering requirements, basic hole system
Appendices
A. Rules for rounding-off tolerances
B. Derivation of fundamental deviations
C. Special notes on tables of limits
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.