Radio-frequency connectors. RF coaxial connectors with inner diameter of outer conductor 5,6 mm (0,22 in). Characteristic impedance 75 ohms (type 1,6/5,6). Characteristic impedance 50 ohms (type 1,8/5,6) with similar mating dimensions

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

15-01-1997

Publisher

British Standards Institution

Committees responsible
National foreword
Introduction
Specification
1 Scope
2 IEC type designation
3 Ratings
4 Climatic categories
5 Dimensions
6 Gauges and reference connectors
7 Survey of patterns
8 Outline dimensions
9 Schedule for type tests
10 Quality assessment procedures
Figures
1 Pin connector
2 Socket connector
3 Untitled
4 Untitled
5 Untitled
6 Gauge for outer contact of pin connector
7 Gauge pin for centre contact of socket connector
8 Free connector (straight) with pin contact, thread
    locking
9 Free connector (right angle) with pin contact,
    thread locking
10 Free connector(straight) with pin contact, for snap-
    on or push-pull locking device
11 Free connector (right angle) with pin contact, for
    snap-on or push-pull locking device
12 Fixed connector (straight) with pin contact, for
    slide-in rack and panel application
13 Fixed connector (right angle) with pin contact, for
    slide-in rack and panel application
14 Fixed connector (right angle, long size) with pin
    contact, for slide-in rack and panel application
15 Panel jack (straight, single hole panel mounting)
    with socket contact
16 Panel jack (right angle, single hole panel mounting)
    with socket contact
17 Fixed connector (single hole panel mounting with
    solder terminations) with socket contact
18 Free adaptor with socket-socket contacts

Radio-frequency (RF) coaxial solder type patterns used with RF cables.

Committee	EPL/46
DevelopmentNote	Also numbered as IEC 60169-13 (08/2005) Reviewed and confirmed by BSI, October 2005. (09/2005)
DocumentType	Standard
Pages	44
PublisherName	British Standards Institution
Status	Current

BS 2011-2.1M:1984	Environmental testing. Tests Test M. Low air pressure
BS EN 61169-1:2013	Radio-frequency connectors Generic specification. General requirements and measuring methods
BS 2011-2.1N:1985	Environmental testing. Tests Test N. Change of temperature
BS 2011-2.1Ca:1977	Environmental testing. Tests Test Ca. Damp heat, steady state
BS EN 60068-2-1:2007	Environmental testing Tests. Test A. Cold
BS 3041-1:1977	Radio-frequency connectors Specification for general requirements and measuring methods
BS EN 60068-2-2:2007	Environmental testing Tests. Test B. Dry heat
BS 2011-2.1T:1981	Environmental testing. Tests Test T. Soldering