DD CEN/TS 14578:2003
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Plastics piping systems for water supply or drainage and sewerage. Glass-reinforced thermosetting plastics (GPR) based on unsaturated polyester resin (UP). Recommended practice for installation
Hardcopy , PDF
30-10-2018
English
07-11-2003
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Procedures
4.1 General
4.2 Special conditions for pipes having a nominal stiffness
less than SN 1250
5 Specific information and recommendations
5.1 General
5.2 Special transportation requirements
5.3 Maximum storage heights on site
5.4 Maximum storage period in direct sunlight
5.5 Any climatic conditions requiring special storage
5.6 Limiting deflections
5.7 Coefficient of linear expansion
5.8 Longitudinal tensile modulus and strength
5.9 Suitability for use in areas exposed to sunlight
5.10 Appropriate jointing system
5.11 Cold bending
5.12 Permitted rates of loss of water and/or pressure
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.