EN 50083-6:1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Cable networks for television signals, sound signals and interactive services - Part 6: Optical equipment
01-10-2003
23-12-1997
Committees responsible
National foreword
Foreword
1 Scope
2 Definitions
2.1 Equipment
2.2 Performance characteristics
3 Methods of measurement
3.1 General measurement requirements
3.2 optical power
3.3 Loss, isolation, directivity, and coupling rates
3.4 Return loss
3.5 Saturation of output power of an optical amplifier
3.6 Influence of polarization
3.7 Central wavelength and spectral width under
modulation
3.8 Linewidth and chirp of transmitters with
singlemode lasers
3.9 Extinction ratio
3.10 Optical modulation index
3.11 Voltage responsivity of an optical receiver
3.12 Frequency range and flatness
3.13 Composite second order distortion (CSO) of optical
transmitters
3.14 Composite triple beats (CTB) of optical
transmitters
3.15 Composite crossmodulation of optical transmitters
3.16 Receiver intermodulation
3.17 CSO of optical amplifiers
3.18 CTB of optical amplifiers
3.19 Carrier to noise ratio
3.20 Method for combined measurement of relative
intensity noise (RIN), optical modulation index
and equivalent input noise current
3.21 Noise figure of optical amplifiers
3.22 Bit error rate (BER)
3.23 Influence of dispersion
4 Universal performance requirements and
recommendations
4.1 Safety
4.2 EMC
4.3 Environmental
4.4 Marking
5 Active equipment
5.1 Optical transmitters
5.2 Optical receivers
5.3 Optical amplifiers
6 Passive equipment
6.1 Connectors and splices
6.2 Multiplexers, splitters, directional couplers and
isolators
Annex A (normative) List of normative references
Figures
1 Measurement of optical power
2 Measurement of optical loss, directivity and
isolation
3 Measurement of the optical return loss
4 Measurement of the saturation of the optical
output power
5 Saturated optical output power
6 Measurement of the polarization stability
7 Measurement of central wavelength and spectral
width under modulation
8 Measurement of the chirp and the linewidth of
transmitters
9 Measurement of the extinction ratio
10 Measurement of the optical modulation index
11 Measurement of the voltage responsivity of an
optical receiver
12 Measurement of the frequency range and flatness
13 Device under test for measuring CSO of optical
transmitters
14 Device under test for measuring CTB of optical
transmitters
15 Device under test for measuring composite
crossmodulation of optical transmitters
16 Arrangement of test equipment for measuring
receiver intermodulation
17 System with internal noise sources
18 PIN-diode receiver
19 Optical transmission system under test
20 Arrangement of test equipment for carrier-to-noise
measurement
21 Measurement setup for determination of the noise
parameters and the optical modulation index
22 Measurement of the noise figure of an optical
amplifier
23 Measurement of the bit error rate
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.