Radio-frequency connectors - Part 51: Sectional specification for RF coaxial connectors with inner diameter of outer conductors 13,5 mm with bayonet lock - Characteristic impedance 50 Ohm (type QLI)

Published date

22-05-2015

Publisher

European Committee for Standards - Electrical

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Mating face and gauge information
4 Quality assessment procedures
5 Instructions for preparation of detail specifications (DS)
6 Marking
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications

IEC 61169-51:2015 provides information and rules for the preparation of detail specifications (DS) for type QLI R.F. coaxial connectors with quick lock. The connectors are normally used with 50 Ohms corrugated cable and flexible cables for middle power applications in an operating range up to 6 GHz. It describes the interface dimensions for general purpose connectors with gauging information and the mandatory tests selected from IEC 61169-1 applicable to all detail specifications relative to type QLI connectors. This specification indicates the recommended performance characteristics to be considered when writing a DS and covers all tests schedules and inspection requirements.

Committee	CLC/SR 46F
DocumentType	Standard
PublisherName	European Committee for Standards - Electrical
Status	Current

Standards	Relationship
NEN EN IEC 61169-51 : 2015	Identical
IEC 61169-51:2015	Identical
PN EN 61169-51 : 2015	Identical
NBN EN 61169-51 : 2015	Identical
VDE 0887-969-51 : 2015	Identical
BS EN 61169-51:2015	Identical
NF EN 61169-51 : 2015	Identical
DIN EN 61169-51 : 2015	Identical
CEI EN 61169-51 : 2015	Identical
I.S. EN 61169-51:2015	Identical
UNE-EN 61169-51:2015	Identical
SN EN 61169-51:2015	Identical

EN 61169-1:2013/AC:2016-02	RADIO-FREQUENCY CONNECTORS - PART 1: GENERIC SPECIFICATION - GENERAL REQUIREMENTS AND MEASURING METHODS (IEC 61169-1:2013)
IEC 61169-1:2013	Radio frequency connectors - Part 1: Generic specification - General requirements and measuring methods
ISO 21207:2015	Corrosion tests in artificial atmospheres — Accelerated corrosion tests involving alternate exposure to corrosion-promoting gases, neutral salt-spray and drying
IEC 60529:1989+AMD1:1999+AMD2:2013 CSV	Degrees of protection provided by enclosures (IP Code)