Name: EN ISO 15118-3:2016
Brand: CEN

Road vehicles - Vehicle to grid Communication interface - Part 3: Physical and data link layer requirements (ISO 15118-3:2015)

Published date

20-04-2016

Publisher

Comite Europeen de Normalisation

European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Conventions
6 System architecture
7 Connection coordination
8 Timings and constants
9 Matching EV - EVSE process
10 EMC requirements
11 Signal coupling
12 Layer 2 interfaces
Annex A (normative) - HomePlug Green PHY on control
pilot line
Annex B (informative) - IEEE 1901.2 G3-PLC profile on
control pilot line
Bibliography

ISO 15118-3:2015 specifies the requirements of the physical and data link layer for a high-level communication, directly between battery electric vehicles (BEV) or plug-in hybrid electric vehicles (PHEV), termed as EV (electric vehicle) [ISO-1], based on a wired communication technology and the fixed electrical charging installation [Electric Vehicle Supply Equipment (EVSE)] used in addition to the basic signalling, as defined in [IEC-1].It covers the overall information exchange between all actors involved in the electrical energy exchange. ISO 15118 (all parts) is applicable for manually connected conductive charging.Only "[IEC-1] modes 3 and 4" EVSEs, with a high-level communication module, are covered by this part of ISO 15118.

Committee	CEN/TC 301
DocumentType	Standard
PublisherName	Comite Europeen de Normalisation
Status	Current

Standards	Relationship
DIN EN ISO 15118-3:2016-08	Identical
BS EN ISO 15118-3:2016	Identical
NEN EN ISO 15118-3 : 2016	Identical
NBN EN ISO 15118-3 : 2016	Identical
PN EN ISO 15118-3 : 2016	Identical
UNE-EN ISO 15118-3:2016	Identical
NS EN ISO 15118-3 : 2016	Identical
UNI EN ISO 15118-3 : 2016	Identical
I.S. EN ISO 15118-3:2016	Identical
ISO 15118-3:2015	Identical
SN EN ISO 15118-3 : 2016	Identical

IEC 62196-2:2016	Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories
IEC TS 62763:2013	Pilot function through a control pilot circuit using PWM (pulse width modulation) and a control pilot wire
IEC 62196-3:2014	Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3: Dimensional compatibility and interchangeability requirements for d.c. and a.c./d.c. pin and contact-tube vehicle couplers
ISO 15118-1:2013	Road vehicles Vehicle to grid communication interface Part 1: General information and use-case definition
ISO 15118-2:2014	Road vehicles Vehicle-to-Grid Communication Interface Part 2: Network and application protocol requirements
IEC 61851-1:2017	Electric vehicle conductive charging system - Part 1: General requirements
IEC 62196-1:2014	Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements