I.S. EN 14648:2007
Current
The latest, up-to-date edition.
BUILDING HARDWARE - FITTINGS FOR SHUTTERS - REQUIREMENTS AND TEST METHODS
Hardcopy , PDF
English
01-01-2007
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
4.1 General
4.2 Category of use (first digit)
4.3 Durability (second digit)
4.4 Mass (third digit)
4.5 Fire resistance (fourth digit)
4.6 Safety in use (fifth digit)
4.7 Corrosion resistance (sixth digit)
4.8 Example of classification of shutter hardware
5 Requirements
5.1 Dangerous substances
5.2 Category of use (first digit)
5.3 Durability (second digit)
5.4 Mass (third digit)
5.5 Fire resistance (fourth digit)
5.6 Safety in use (fifth digit)
5.7 Corrosion resistance (sixth digit)
6 Test equipment
6.1 Test rig
6.2 Beam to accommodate the frame hinges
6.3 Essentially the beam has a cross-section of (100 X 100)
mm, and a length of 1600 mm. Test shutter
6.4 Moving device
7 Test method
7.1 Samples
7.2 Procedures
7.3 Durability test
7.4 Overload tests
7.5 Corrosion resistance test
8 Marking
Annex A (informative) Shutter hardware terminology
Annex B (informative) Deviation after the durability test
Annex C (informative) Test equipment
Annex D (normative) Flow chart of test procedures
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.