I.S. EN 60317-0-5:2007
Current
The latest, up-to-date edition.
SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 0-5: GENERAL REQUIREMENTS - GLASS-FIBRE BRAIDED RESIN OR VARNISH IMPREGNATED, BARE OR ENAMELLED RECTANGULAR COPPER WIRE
Hardcopy , PDF
English
01-01-2007
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Definitions, general notes on methods of test and
appearance
3.1 Definitions
3.2 General notes on methods of test
3.3 Appearance
4 Dimensions
4.1 Conductor dimensions
4.2 Tolerance on conductor dimensions
4.3 Rounding of corners
4.4 Increase in dimensions due to the insulation
4.5 Overall dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
8.1 Mandrel winding test
8.2 Adherence test
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) Nominal cross-sectional areas for
preferred and intermediate sizes
Annex ZA (normative) Normative references to international
publications with their corresponding
European publications
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.