I.S. EN ISO 6789:2003
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
ASSEMBLY TOOLS FOR SCREWS AND NUTS - HAND TORQUE TOOLS - REQUIREMENTS AND TEST METHODS FOR DESIGN CONFORMANCE TESTING, QUALITY CONFORMANCE TESTING AND RECALIBRATION PROCEDURE
Hardcopy , PDF
26-03-2017
English
01-01-2003
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Requirements
5.1 Design conformance testing
5.2 Quality conformance testing
5.3 Recalibration
6 Calibration
6.1 Calibration device
6.2 Calibration temperature
6.3 Calibration conditions
6.4 Calibration sequence
6.5 Calibration examples
7 Marking
Annex A (normative) Indicating torque tools: Type I
Annex B (normative) Setting torque tools: Type II
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.