NBN EN 60384-25 : 2007

1 General
  1.1 Scope
  1.2 Object
  1.3 Normative references
  1.4 Information to be given in a detail specification
  1.5 Terms and definitions
  1.6 Marking
2 Preferred rating and characteristics
  2.1 Preferred characteristics
  2.2 Preferred values of ratings
3 Quality assessment procedures
  3.1 Primary stage of manufacture
  3.2 Structurally similar components
  3.3 Declaration of conformity (basic requirements)
  3.4 Test schedule and requirement for initial assessment
       (mandatory and optional tests)
  3.5 Quality conformance inspection
4 Test and measurement procedures
  4.1 Preliminary drying
  4.2 Measuring conditions
  4.3 Mounting
  4.4 Visual examination and check of dimensions
  4.5 Electrical tests
  4.6 Resistance to soldering heat
  4.7 Solderability
  4.8 Shear test
  4.9 Substrate bending test
  4.10 Rapid change of temperature
  4.11 Climatic sequence
  4.12 Damp heat, steady state
  4.13 Characteristics at high and low temperature
  4.14 Surge
  4.15 Endurance
  4.16 Storage at high temperature
  4.17 Charge and discharge (if required by the detail specification)
  4.18 Component solvent resistance (if applicable)
  4.19 Solvent resistance of the marking (if applicable)
  4.20 High surge current (if applicable)
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications