NEN EN 13108-4 : 2016 C1 2017

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
  3.1 Terms and definitions
  3.2 Symbols and abbreviations
4 Requirements for constituent materials
  4.1 General
  4.2 Binder
       4.2.1 General
       4.2.2 Selection of binder
  4.3 Aggregates
       4.3.1 Coarse aggregate
       4.3.2 Fine aggregate
       4.3.3 All-in aggregates
       4.3.4 Added filler
  4.4 Reclaimed asphalt
  4.5 Additives
  4.6 Coated chippings
5 Requirements for the mixture
  5.1 Declaration of the target composition
  5.2 Composition, grading and binder content
       5.2.1 Composition
       5.2.2 Grading
       5.2.3 Binder content
       5.2.4 Binder volume
       5.2.5 Additives
  5.3 Coating and homogeneity
  5.4 Void content
  5.5 Water sensitivity
  5.6 Reaction to fire
  5.7 Resistance to permanent deformation
  5.8 Stiffness
  5.9 Resistance to fuel for application on airfields
  5.10 Resistance to de-icing fluid for application on airfields
  5.11 Temperature of the mixture
  5.12 Over-specification
  5.13 Durability
6 Evaluation of conformity
7 Identification
Annex A (normative) Calculations of the penetration or the
                    softening point of the binder of a mixture
                    when reclaimed asphalt is used
      A.1 General
      A.2 Calculation of the penetration of the binder of a
          mixture
      A.3 Calculation of the softening point of the binder
          of a mixture
Annex B (normative) Natural asphalt
      B.1 Scope
      B.2 Terms and definitions
      B.3 Requirements
      B.4 Methods of use
      B.5 Determination ash content
Annex C (normative) Coated chippings for application to
                    surface course
      C.1 Scope
      C.2 Chippings
      C.3 Binder content
      C.4 Evaluation of conformity
      C.5 Identification
Annex ZA (informative) Clauses of this European Standard
                       addressing the provisions of the EU
                       Construction Product directive
      ZA.1 Scope and relevant characteristics
      ZA.2 Procedure(s) for attestation of conformity of
           Hot Rolled Asphalt
      ZA.3 CE marking and labelling
Bibliography