NEN EN 1870-10 : 2013

Foreword
0 Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of hazards
5 Safety requirements and/or measures
  5.1 Controls
      5.1.1 Safety and reliability of control systems
      5.1.2 Position of controls
      5.1.3 Starting
      5.1.4 Normal stopping
      5.1.5 Emergency stop
      5.1.6 Integrated feed
      5.1.7 Mode selection
      5.1.8 Failure of the power supply
      5.1.9 Failure of the control circuits
  5.2 Protection against mechanical hazards
      5.2.1 Stability
      5.2.2 Risk of break up during operation
      5.2.3 Tool holder and tool design
      5.2.4 Braking
      5.2.5 Devices to minimise the possibility or effect of
            ejection
      5.2.6 Workpiece supports and guides
      5.2.7 Prevention of access to moving parts
      5.2.8 Clamping devices
  5.3 Protection against non-mechanical hazards
      5.3.1 Fire
      5.3.2 Noise
      5.3.3 Emission of chips and dust
      5.3.4 Electricity
      5.3.5 Ergonomics and handling
      5.3.6 Pneumatics
      5.3.7 Hydraulics
      5.3.8 Radiation
      5.3.9 Laser
      5.3.10 Static electricity
      5.3.11 Errors of fitting
      5.3.12 Isolation
      5.3.13 Maintenance
6 Information for use
  6.1 Warning devices
  6.2 Marking
  6.3 Instruction handbook
Annex A (normative) Saw spindle dimensional tolerances
Annex B (informative) Safe working practice
Annex ZA (informative) Relationship of this document with EC
                       Directives
Bibliography