• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

NF EN 613 : 2001 AMD 1 2003

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

INDEPENDENT GAS-FIRED CONVECTION HEATERS

Amendment of

NF EN 613:2001

Superseded date

10-01-2023

Published date

12-01-2013

Avant-propos
1 Domaine d'application
2 Références normatives
3 Termes et définitions
  3.1 Appareils de chauffage indépendants à convection
  3.2 Gaz
  3.3 Construction des appareils
  3.4 Préréglages et commandes
  3.5 Performance des appareils
  3.6 Marquage de l'appareil et de l'emballage
4 Classification des appareils
  4.1 Classification selon la nature des gaz utilisés
       (catégories)
  4.2 Classification selon le mode d'évacuation des
       produits de combustion
5 Caractéristiques de construction
  5.1 Généralités
  5.2 Dispositifs de réglage, de régulation et de sécurité
  5.3 Dispositifs d'allumage
  5.4 Dispositifs de surveillance de flamme
  5.5 Brûleurs
  5.6 Moteurs et ventilateurs
  5.7 Prises de pression
6 Exigences de fonctionnement
  6.1 Généralités
  6.2 Étanchéité des circuits de gaz et de combustion et
       évacuatcernant les exigences essentielles ou d'autres
       dispositions des Directives UE
  6.3 Débits calorifiques
  6.4 Température des diverses parties de l'appareil
  6.5 Allumage, interallumage et stabilité des flammes
  6.6 Régulateurs de pression
  6.7 Combustion
  6.8 Charbonnement
  6.9 Système de controle de l'évacuation des produits de
       combustion
  6.10 Dispositif de surveillance de flamme
  6.11 Rendement
7 Méthodes d'essai
  7.1 Généralités
  7.2 Étanchéité des circuits de gaz et de combustion et
       évacuation des produits de combustion
  7.3 Débits calorifiques
  7.4 Température des différentes parties de l'appareil
  7.5 Allumage, interallumage et stabilité des flammes
  7.6 Régulateurs de pression
  7.7 Combustion
  7.8 Charbonnement (appareils à effet décoratif de flamme
       seulement)
  7.9 Dispositif de controle de l'évacuation des produits
       de combustion
  7.10 Dispositif de surveillance de flamme
  7.11 Rendement
8 Marquage et notices
  8.1 Marquage
  8.2 Notices
Annexe A (informative) Situations nationales
Annexe B (informative) Règles d'équivalence
Annexe C (normative)
Annexe D (informative) Composition de la ligne gaz
Annexe E (informative) Modes d'identification des types de
                        gaz en usage dans les différents pays
Annexe F (normative) Circuits d'allumage à haute tension
Annexe G (normative) Appareillage pour la détermination de
                        l'indice de noircissement
Annexe H (informative) Symboles et abréviations
Annexe J (normative) Calcul de conversion des NO[x]
Annexe K (normative) Conditions nationales particulières
Annexe L (informative) Divergences A
Annexe ZA (informative) Articles de la présente Norme
                        Européenne concernant les exigences
                        essentielles ou d'autres dispositions
                        des Directives UE
Bibliographie

Describes the requirements and test methods for the construction, safety, marking and rational use of energy of independent gas-fired convection heating appliances, hereafter referred to as applicances.

DevelopmentNote
Indice de classement: D35-332. Supersedes NF HD 1002 and NFD 35 377. (05/2001)
DocumentType
Standard
PublisherName
Association Francaise de Normalisation
Status
Superseded
SupersededBy
Supersedes

NF EN ISO 228-1 : 2003 PIPE THREADS WHERE PRESSURE-TIGHT JOINTS ARE NOT MADE ON THE THREADS - PART 1: DIMENSIONS, TOLERANCES AND DESIGNATION
IEC 60730-2-9:2015 RLV Automatic electrical controls - Part 2-9: Particular requirements for temperature sensing controls
NF EN 437 : 2003 + A1 2009 TEST GASES - TEST PRESSURES - APPLIANCE CATEGORIES
ISO 274:1975 Copper tubes of circular section — Dimensions
NF EN 126 : 2012 MULTIFUNCTIONAL CONTROLS FOR GAS BURNING APPLIANCES
NF EN 60529 : 92 AMD 2 2014 DEGREES OF PROTECTION PROVIDED BY ENCLOSURES (IP CODE)
NF EN 60335-1 : 2013 HOUSEHOLD AND SIMILAR ELECTRICAL APPLIANCES - SAFETY - PART 1: GENERAL REQUIREMENTS
ISO 7-1:1994 Pipe threads where pressure-tight joints are made on the threads Part 1: Dimensions, tolerances and designation
IEC 60529:1989+AMD1:1999+AMD2:2013 CSV Degrees of protection provided by enclosures (IP Code)
CR 1404:1994 Determination of emissions from appliances burning gaseous fuels during type-testing
NF EN 257 : 2011 MECHANICAL THERMOSTATS FOR GAS-BURNING APPLIANCES
NF EN ISO 3166-1 : 2014 CODES FOR THE REPRESENTATION OF NAMES OF COUNTRIES AND THEIR SUBDIVISION - PART 1: COUNTRY CODES
NF EN 125 : 2010 + A1 2016 FLAME SUPERVISION DEVICES FOR GAS BURNING APPLIANCES - THERMOELECTRIC FLAME SUPERVISION DEVICES
NF EN 161 : 2011 + A3 2013 AUTOMATIC SHUT-OFF VALVES FOR GAS BURNERS AND GAS APPLIANCES
NF EN 298 : 2012 AUTOMATIC BURNER CONTROL SYSTEMS FOR BURNERS AND APPLIANCES BURNING GASEOUS OR LIQUID FUELS
NF EN 88 : 91 AMD 1 96 PRESSURE GOVERNORS FOR GAS APPLIANCES FOR INLET PRESSURES UP TO 200 MBAR
NF EN 60730-2-9 : 2013 AUTOMATIC ELECTRICAL CONTROLS FOR HOUSEHOLD AND SIMILAR USE - PART 2-9: PARTICULAR REQUIREMENTS FOR TEMPERATURE SENSING CONTROLS
1990/396/EEC : 1990 COUNCIL DIRECTIVE OF 29 JUNE 1990 ON THE APPROXIMATION OF THE LAWS OF THE MEMBER STATES RELATING TO APPLIANCES BURNING GASEOUS FUELS

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.