SN EN ISO 13535 : 2000

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
   3.1 Terms and definitions
   3.2 Abbreviated terms
4 Design
   4.1 General
   4.2 Design conditions
   4.3 Strength analysis
   4.4 Size class
   4.5 Contact surface radii
   4.6 Rating
   4.7 Design safety factor
   4.8 Shear strength
   4.9 Specific equipment
   4.10 Design documentation
5 Design verification test
   5.1 General
   5.2 Sampling of test units
   5.3 Test procedures
   5.4 Determination of load rating
   5.5 Alternative design verification test
        procedure and rating
   5.6 Design verification test apparatus
   5.7 Design changes
   5.8 Records
6 Materials requirements
   6.1 General
   6.2 Written specifications
   6.3 Mechanical properties
   6.4 Material qualification
   6.5 Manufacture
   6.6 Chemical composition
7 Welding requirements
   7.1 General
   7.2 Welding qualifications
   7.3 Written documentation
   7.4 Control of consumables
   7.5 Weld properties
   7.6 Post-weld heat-treatment
   7.7 Fabrication welds
   7.8 Repair welds
8 Quality control
   8.1 General
   8.2 Quality control personnel qualifications
   8.3 Measuring and test equipment
   8.4 Quality control for specific equipment
        and components
   8.5 Dimensional verification
   8.6 Proof load test
   8.7 Hydrostatic testing
   8.8 Functional testing
9 Equipment
   9.1 General
   9.2 Hoisting sheaves
   9.3 Travelling blocks
   9.4 Block-to-hook adapters
   9.5 Connectors, link-adapters and drill-pipe
        elevator-adapters
   9.6 Drilling hooks
   9.7 Elevator links
   9.8 Elevators
   9.9 Rotary swivels
   9.10 Power swivels
   9.11 Power subs
   9.12 Wireline anchors
   9.13 Drill-string motion compensators
   9.14 Pressure vessels and piping
   9.15 Anti-friction bearings
   9.16 Safety clamps when capable of being used
        as hoisting equipment
10 Marking
   10.1 Product marking
   10.2 Rating marking
   10.3 Composite equipment marking
   10.4 Component traceability
   10.5 Serialization
   10.6 Marking method
11 Documentation
   11.1 General
   11.2 Documentation to be kept by the
        manufacturer
   11.3 Documentation to be delivered with the
        equipment
Annex A (normative) Supplementary requirements
A.1 General
A.2 SR 1 Proof load test
A.3 SR 2 Low temperature test
A.4 SR 3 Data book
A.5 SR 4 Additional volumetric examination of
     castings
A.6 SR 5 Volumetric examination of wrought
     material
Annex B (normative) Guide dollies
B.1 General
B.2 Principal loading conditions and
     corresponding safety factors
B.3 Loads and load combinations
B.4 Fatigue considerations
B.5 Special safety precautions
Annex C (informative) Guidance for qualification
        of heat-treatment equipment
C.1 Temperature tolerance
C.2 Furnace calibration
C.3 Instruments
Bibliography