Standard Test Method for Rheological (Flow) Properties of Elastomeric Sealants

Available format(s)

PDF

Language(s)

English

Published date

06-01-2015

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 04.07, 2015 Specifies a laboratory procedure for the determination of rheological (flow) properties of single and multicomponent chemically curing sealants for use in building construction.

1.1This test method describes a laboratory procedure for the determination of rheological (flow) properties of single- and multicomponent chemically curing sealants for use in building construction.

1.2Other suitable flow characteristics may be agreed upon between the seller and purchaser or specifier. Special nonsag properties and lower flow characteristics may be required for use in sloping joints where absolute leveling is not desired.

Note 1:The sealants are supplied in various rheological properties ranging from pourable fluids to stiff nonsagging pastes. Multicomponent sealants are supplied as a base component with an activator or curing agent separately packaged. After mixing the multiple parts, the sealant is ready for application. Single-component sealants are supplied ready for use upon opening of the package and usually depend on the external environment for cure.

1.3This test method describes four types of joint sealants:

1.3.1Type I—Single-component flowable or self-leveling,

1.3.2Type II—Single-component nonsag,

1.3.3Type III—Multicomponent flowable or self-leveling, and

1.3.4Type IV—Multicomponent nonsag.

1.4The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee	C 24
DocumentType	Redline
Pages	3
PublisherName	American Society for Testing and Materials
Status	Current

ASTM C 1299 : 2003	Standard Guide for Use in Selection of Liquid-Applied Sealants (Withdrawn 2012)
ASTM C 647 : 2008	Standard Guide to Properties and Tests of Mastics and Coating Finishes for Thermal Insulation
ASTM C 1021 : 2008	Standard Practice for Laboratories Engaged in Testing of Building Sealants
ASTM C 1369 : 2007 : R2014	Standard Specification for Secondary Edge Sealants for Structurally Glazed Insulating Glass Units
ASTM D 5893/D5893M : 2016 : REDLINE	Standard Specification for Cold Applied, Single Component, Chemically Curing Silicone Joint Sealant for Portland Cement Concrete Pavements
ASTM C 1021 : 2008 : R2014	Standard Practice for Laboratories Engaged in Testing of Building Sealants
ASTM D 8138 : 2018	Standard Specification for Preformed Silicone Joint Sealing System for Bridges
ASTM C 1369 : 2007	Standard Specification for Secondary Edge Sealants for Structurally Glazed Insulating Glass Units
ASTM C 647 : 2008 : R2013	Standard Guide to Properties and Tests of Mastics and Coating Finishes for Thermal Insulation
ASTM C 920 : 2018 : REDLINE	Standard Specification for Elastomeric Joint Sealants
ASTM D 5893 : 2004	Standard Specification for Cold Applied, Single Component, Chemically Curing Silicone Joint Sealant for Portland Cement Concrete Pavements