EN 60317-0-6:2001/A1:2006
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
SPECIFICATION FOR PARTICULAR TYPES OF WINDING WIRES - PART 0-6: GENERAL REQUIREMENTS - GLASS-FIBRE WOUND RESIN OR VARNISH IMPREGNATED, BARE OR ENAMELLED ROUND COPPER WIRE
08-19-2020
01-12-2013
INTRODUCTION
1 Scope
2 Normative references
3 Definitions, general notes on methods of test and
appearance
3.1 Definitions
3.2 General notes on methods of test
3.3 Appearance
4 Dimensions
4.1 Conductor diameter
4.2 Out of roundness of conductor
4.3 Minimum increase in diameter due to the covering
4.4 Maximum overall diameter
5 Electrical resistance
6 Elongation
7 Springiness
7.1 Nominal conductor diameters up to and including
1,600 mm
7.2 Nominal conductor diameters over 1,600 mm
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvent
13 Breakdown voltage
13.1 Glass-fibre covered round copper wires
13.2 Glass-fibre covered enamelled round copper wires
14 Continuity of covering
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to hydrolysis and to transformer oil
21 Loss of mass
23 Pin hole
30 Packaging
Annex A (informative) Diameters for intermediate nominal
conductor diameters (R40)
Annex B (informative) Resistance
Annex C (informative) High temperature failure test
Annex ZA (normative) Normative references to international
publications with their corresponding European
publications
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.