I.S. EN 50083-10:2002
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 10: SYSTEM PERFORMANCE FOR RETURN PATHS
Hardcopy , PDF
06-24-2014
English
01-01-2002
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
1 Scope
1.1 General
1.2 Specific scope of this Part 10
2 Normative references
3 Terms, definitions, symbols and abbreviations
3.1 Terms and definitions
3.2 Symbols
3.3 Abbreviations
4 Methods of measurement
4.1 Setup of the network
4.2 Measurement of signal level
4.3 Measurement of amplitude response variation
4.4 Measurement of signal to noise ratio (S/N)
4.5 Measurement of multiple interference
4.6 Measurement of impulse noise
4.7 Measurement of echo ratio
4.8 Measurement of group delay variation
4.9 Measurement of frequency error
4.10 Measurement of Bit Error Rate (BER)
5 System performance requirements
5.1 Introduction
5.2 Analogue parameters influencing system
performance
5.3 General requirements
5.4 Specific system performance requirements
6 System performance recommendations
6.1 Proposal for the use of the return path bandwidth
Annex A (informative) System performance requirements for
different modulation techniques
Annex B (normative) Correction factors for noise
Annex C (informative) Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.