I.S. EN IEC 61347-2-14:2018&A11:2021
Current
The latest, up-to-date edition.
Lamp controlgear - Part 2-14: Particular requirements for DC and/or AC supplied electronic controlgear for fluorescent induction lamps
Hardcopy , PDF
English
12-07-2021
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Fault conditions
15 Protection of associated components
16 Abnormal conditions
17 Construction
18 Creepage distances and clearances
19 Screws, current-carrying parts and connections
20 Resistance to heat, fire and tracking
21 Resistance to corrosion
Annex A (normative) Test to establish whether a conductive part is a live part which
may cause an electric shock
Annex B (normative) Particular requirements for thermally protected lamp controlgear
Annex C (normative) Particular requirements for electronic lamp controlgear with means of protection against overheating
Annex D (normative) Requirements for carrying out the heating tests of thermally protected lamp controlgear
Annex E (normative) Use of constant S other than 4 500 in tw tests
Annex F (normative) Draught-proof enclosure
Annex G (normative) Explanation of the derivation of the values of pulse voltages
Annex H (normative) Tests
Annex I (normative) Additional requirements for built-in magnetic ballast with double or reinforced insulation
Annex J (normative) Particular additional safety requirements for DC and/or AC supplied electronic controlgear for emergency lighting
Annex K (informative) Conformity testing during manufacture
Annex L (normative) Particular additional requirements for controlgear providing SELV
Annex M (informative) Dielectric strength test voltages for controlgear intended for the use in impulse withstand Category III
Annex N (normative) Requirements for insulation materials used for double or reinforced insulation
Annex O (normative) Additional requirements for built-in electronic controlgear with double or reinforced insulation
Annex P (normative) Creepage distances and clearances and distance through insulation (DTI) for lamp controlgear which are protected against pollution by the use
of coating or potting
Annex Q (informative) Example for Up calculation
Annex R (informative) Concept of creepage distances and clearances
Annex S (informative) Examples of controlgear insulation coordination
Annex T (informative) Creepage distances and clearances for controlgear with a higher degree
of availability (impulse withstand category III)
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.