NEN EN 13483 : 2013

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Materials and construction
6 Pressure requirements
7 Dimensions and tolerances
8 Physical properties
9 End fittings
10 Type tests
11 Frequency of testing
12 Marking
Annex A (normative) Test method for determination of low
                      temperature class resistance at
                      -30 degree C and -40 degree C
Annex B (normative) Test method for pressure requirements
                      of vapour recovery hoses and tubes
Annex C (normative) Test method for determination of change
                      in length due to swelling
Annex D (normative) Test method for determination of
                      pressure loss
Annex E (normative) Method for determination of adhesion
                      between components
Annex F (normative) Test method for the determination of
                      low temperature class flexibility
Annex G (normative) Test method for the determination of
                      rate of fuel permeation
Annex H (normative) Test method for flammability
Annex I (normative) Test method for the determination of
                      leakage (leak test)
Annex J (normative) Test method for fatigue strength under
                      reversed bending stresses (flex test)
Annex K (normative) End-fitting pull-off test
Annex L (normative) Test frequency for type tests and
                      routine tests
Annex M (informative) Test frequency for production acceptance
                      tests