We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • I.S. EN ISO 18064:2014

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You have already added this standard to your Watchlist.
    Visit My Watchlist to view the full list.

    THERMOPLASTIC ELASTOMERS - NOMENCLATURE AND ABBREVIATED TERMS (ISO 18064:2014)

    Available format(s):  Hardcopy, PDF

    Superseded date:  17-06-2022

    Language(s):  English

    Published date:  01-01-2014

    Publisher:  National Standards Authority of Ireland

    Add to Watchlist

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Foreword
    Introduction
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Nomenclature system
    5 Categories of thermoplastic elastomer
    6 Materials in each TPE category
    Annex A (informative) - Formerly used abbreviated
            terms

    Abstract - (Show below) - (Hide below)

    Specifies a nomenclature system for thermoplastic elastomers based on the chemical composition of the polymer or polymers involved.

    General Product Information - (Show below) - (Hide below)

    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Superseded
    Superseded By
    Supersedes

    Standards Referencing This Book - (Show below) - (Hide below)

    ISO 1043-1:2011 Plastics Symbols and abbreviated terms Part 1: Basic polymers and their special characteristics
    ISO 1629:2013 Rubber and latices Nomenclature
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective