We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • ASTM E 1925 : 2004

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    Specifiction for Engineering and Design Criteria for Rigid Wall Relocatable Structures

    Available format(s):  Hardcopy, PDF

    Superseded date:  11-11-2014

    Language(s):  English

    Published date:  01-10-2004

    Publisher:  American Society for Testing and Materials

    Add to Watchlist

    Add To Cart

    Scope - (Show below) - (Hide below)

    1.1 This specification covers engineering and design criteria required for the development of rigid wall relocatable structures (RWRS) and shall be applied to the design of expandable and non-expandable RWRSs. This specification applies to present engineering and design requirements for effective RWRSs which are operable in a variety of environments without degradation and are capable of all specified transport modes. This specification shall be applied to the design of expandable and non-expandable RWRSs. This specification is a conversion of a military standard that was approved by all departments and agencies of the Department of Defense.

    1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parenthesis are for information only.

    1.3 The following safety hazards caveat pertains only to the test required portion, Section 10, of this specification. This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    General Product Information - (Show below) - (Hide below)

    Committee E 06
    Document Type Standard
    Publisher American Society for Testing and Materials
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    ASTM E 631 : 2015 Standard Terminology of Building Constructions
    ASTM E 1975 : 2018 Standard Specification for Shelter, Electrical, Equipment S-280/G
    ASTM E 2517 : 2013 Standard Specification for Cargo Bed Cover, Type III (M35A2, 2 1/2 Ton Cargo Truck/M1078, 2 1/2 Ton Lightweight Medium Tactical Vehicle (LMTV)/ M1082, 2 1/2 Ton LMTV Trailer)
    ASTM E 1749 : 2018 Standard Terminology Relating to Rigid Wall Relocatable Shelters
    ASTM E 2377 : 2018 Standard Specification for Shelter, Electrical Equipment, Lightweight
    ASTM E 1977 : 2018 Standard Specification for Shelter, Tactical, Expandable, One-Side
    ASTM E 2462 : 2018 Standard Performance Specification for Cargo Bed Cover (CBC) HMMWV, Type I
    ASTM E 1978 : 2018 Standard Specification for Shelter, Tactical, Expandable, Two-Side
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective