BS 5341-6.5:1992

Committees responsible
National foreword
Vocabulary
0. Introduction
1. Scope and field of application
2. References
3. Terminology
4. Visible defects
5. Material
6. Raised material caused by marking of rings
7. Machining of periphery and sides - Unintentional
    departure from ideal profile and flatness
Tables
1. Permissible values of size, number and spacing of
    pores, cavities and sand inclusions
2. Permissible size of indentations and depressions
3. Maximum size of burrs for all sizes of ring
4. Edge material removal in deburr operations
5. Permissible size of chipping and defects on uncoated
    rings on peripheral edges, peripheral edges of the
    gap and outside gap corners
6. Permissible size of chipping and defects on coated
    rings with chromium-plated periphery, on peripheral
    edges, peripheral edges of the gap and outside
    gap corners
7. Permissible size of chipping and defects on spray-
    coated rings on peripheral edges, peripheral edges
    of the gap and outside gap corners
8. Permissible size of chipping and defects on chamfers
    at the peripheral edge and peripheral edge of the gap
9. Permissible size of chipping and defects on inside
    gap corners
10. Test conditions to measure tangential force loss
11. Maximum permitted raised material
12. Permissible side face unevenness in the
    circumferential direction
13. Permissible wind
Figures
1. Chipping on peripheral edges of the gap
2. Chipping on peripheral edges
3. Chipping on outside gap corners
4. Combination of figures 1 and 3
5. Chipping on oppposite gap corners
6. Chipping on chamfers