EN 50109-2-5:1995

Withdrawn

Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 2-5: Particular requirements for the termination of twin-ax cable for databus applications

Withdrawn date

23-07-2013

Published date

22-06-1995

Publisher

European Committee for Standards - Electrical

Foreword
Introduction
1 Scope
2 Normative references
3 Definitions
4 Requirements
5 Test and acceptance requirements
6 Classification and designation
7 User information
Annexes
A Crimping tool description (normative)
B Test contacts (normative)
C Methods of test for crimped joints (normative)
D Mechanical endurance testing (normative)
E Bibliography

Part 2-5 of this European Standard specifies detail requirements for hand crimping tools incorporating a system of multiple indentors for use with Databus contacts of electrical connectors and similar components. Two tools are covered, as follows: a tool for contacts with crimp barrel size 22 (tool reference EN 50109-2-5-001), see clause 5; a tool for contacts with crimp barrel size 20 (tool reference EN 50109-2-5-002), see clause 5. It includes requirements for crimped joints made with the tools

Committee	CLC/TC 46X
DocumentType	Standard
PublisherName	European Committee for Standards - Electrical
Status	Withdrawn

Standards	Relationship
DIN EN 50109-2-5:1995-11	Identical
NBN EN 50109 2-5 : 2000	Identical
CEI EN 50109-2-5 : 1997	Identical
SN EN 50109-2-5 : 1995	Identical
NF EN 50109-2-5 : 2004	Identical
NEN EN 50109-2-5 : 1995	Identical
UNE-EN 50109-2-5:1993	Identical
BS EN 50109-2-5:1996	Identical
I.S. EN 50109-2-5:1997	Identical
PN EN 50109-2-5 : 2002	Identical

ISO 6507-1:2005	Metallic materials Vickers hardness test Part 1: Test method
CECC 22000 : 1993	GENERIC SPECIFICATION: RADIO FREQUENCY COAXIAL CONNECTORS
ISO 6507-2:2005	Metallic materials Vickers hardness test Part 2: Verification and calibration of testing machines
ISO 6507-3:2005	Metallic materials Vickers hardness test Part 3: Calibration of reference blocks
ISO 468:1982	Surface roughness — Parameters, their values and general rules for specifying requirements
EN 50109-1:1995	Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 1: General requirements and tests
EN 50109-2-3:1995	Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 2-3: Particular requirements for contacts of electrical connectors
EN 175200:1996	Sectional Specification: Circular connectors
ISO 4287-1:1984	Surface roughness — Terminology — Part 1: Surface and its parameters